SiBE811120
Operation Manual
Photocatalytic Air Purifier L-Series
19
12
Preparation of remote controller
A battery is already set in the remote controller.
• The remote controller can be used only after pulling out the
clear sheet.
Clear sheet
Battery replacement
1
2
3
4
Move the tab of the cover on the rear of
the remote controller in the direction of
the arrow.
Pull out the cover.
Replace the battery.
Close the cover to its original position.
Tab
3
1
2
4
Battery
Adjust the + side of
the battery to the +
side of the cover and
insert the cover.
NOTE
Battery
Remote controller
• Store the batteries where babies and children can not reach them.
If, by chance, a battery is swallowed, make sure to contact a doctor immediately.
• When discarding batteries, cover the terminals of the batteries with tape.
If mixed with other metal or batteries, heat, explosion or combustion may occur.
• The replacement target is about 1 year but if reception becomes difficult, replace the battery with a new coin type CR2025 (lithium) battery.
• It may be necessary to replace a coin type battery which is approaching its expiration date before the recommended date.
• In order to prevent malfunctions or injuries due to leaking or explosions, make sure to remove the coin type battery when the unit will not be
used for a long period of time.
• The coin type battery which comes with the remote controller is for the initial operation. The coin type battery may run down in less than
1 year.
• Be careful not to drop or get the remote controller wet. (It causes malfunction.)
• The signals may not be received very well because of electronic lighting style fluorescent lamps (such as inverter fluorescent lamps) in the
same room.
• Do not use the remote controller close to the lighting equipment (within 1m).
(The sensitivity of the main unit to the signal from the remote controller may be weakened and the colour of the unit may change.)
Insert the power plug into an
electrical socket.
Electrical socket
Power plug
You can adjust the length of
the power supply cord by
rolling up the extra part.
How to use
• Point the transmitter of the remote controller toward the
receiver of the unit.
If there is an obstruction to the signal, such as a curtain, the
unit may not receive the signal.
• The distance from which the remote controller can transmit is
about 6m.
[View from above]
Receiver
30˚
30˚
5m
Detection area
6m
5m
Transmitter
