SiBE811120
Operation Manual
Photocatalytic Air Purifier L-Series
21
14
To change the airflow manually
Airflow manual operation
Press .
“ (Quiet)”
“ (Low)”
“ (Standard)”
“ (High)”
To clean pollen
Anti-pollen operation
Press .
To operate quietly when you are sleeping
Sleep mode operation
Press .
To change the brightness of the unit display lamp
Press .
Bright
Dimmed
OFF
< Other display lamp >
Bright
Dimmed
Dimmed
NOTE
ATTENTION
Start / Stop
Auto fan operation
Turbo operation
Quiet operation
Anti-pollen operation
Sleep mode operation
Timer operation
Childproof lock
Press .
• The operation mode changes each time the button is pressed.
“ (Auto fan)”
“ (Quiet)”
“ (Low)”
“ (Standard)”
“Stop”
“ (Sleep mode)”
“ (Anti-pollen)”
“ (Turbo)”
“ (High)”
• Do not start or stop operation by disconnecting or reconnecting the power plug
except in the case of malfunction.
• Do not move the unit during operation.
It may cause operational issues or malfunction.
< Air quality sensor lamp /
Odour sensor lamp >
• The brightness of the unit display lamp
changes each time the button is
pressed.
• It is only the air quality sensor lamp
and the odour sensor lamp which
completely go off.
• The sleep mode operation lamp and one of the
airflow rate lamps “ (Quiet)” or “ (Low)” light
up.
• Each time the button is pressed, the airflow rate changes
as follows.
• Operation stops for safety when the front panel is
opened during operation.
When any malfunction occurs during
operation
• If the unit display is abnormally lit or the signal from
the remote controller can not be received during
operation due to electric lighting or radio
interference, disconnect the power plug once. After
3 seconds or more, reconnect the power plug and
start operation.
• The default setting for the airflow rate is “ (Auto
fan)” airflow. When you disconnect the power plug or
remove the front panel, the setting for the airflow rate
returns to “Auto fan”.
• Before cleaning, make sure to stop operation and
disconnect the power plug.
• The airflow rate is automatically selected from “
(Quiet)”, “ (Low)”, “ (Standard)”, or “ (High)”
according to the uncleanness level of the air.
• The purifying capacity improves as the airflow rate
increases.
• A high airflow rate quickly removes any contaminants
in the air. This is convenient to use when cleaning
the room.
• A gentle flow of air is discharged. Use this operation
especially while sleeping.
During the quiet operation, the deodorising
performance decreases. If the room is not
deodorised well, please use the “Standard” or
stronger operation mode.
• While the lock is engaged, the operation of the unit
and the remote controller are limited to prevent small
children from mishandling them.
• The remaining time is indicated by the OFF TIMER
lamp.
• The set time can also be changed when the button is
pressed while the timer is counting.
• The airflow rate is automatically selected from “
(Quiet)” or “ (Low)” according to the cleanliness
level of the air.
• This is convenient to use when sleeping.
• The airflow rate switches over between
“ (Standard)” and “ (Low)” every 5 minutes and
produces a moderate air stream to catch the pollen
before it drops on the floor.
Operation with the button on the unit
