Operation Manual
SiBE811120
24
Photocatalytic Air Purifier L-Series
4.7
Removing and Attaching Each Part
17
1
Push
Clip
2
Note
3
Handles
UNIT1
1)
Pull
2)
Up
4
Handles
1)
Pull
2)
Up
1
Handles
1)
2
Handles
UNIT1
1)
3
Other tabs
(3 locations)
UNIT1
4
Removing and Attaching Each Part
Remove the front panel.
Front panel
(1 each on right and left)
Remove the prefilter.
Pull the prefilter to remove it.
Tabs
(2 each on
right an left)
Remove UNIT1.
Use a vacuum cleaner to
remove the dust before
removing the prefilter.
Remove the deodorising catalyst unit.
Deodorising catalyst unit
Remove
Attach the deodorising catalyst unit.
Deodorising
catalyst unit
Fit here.
Attach UNIT1.
Fit here.
Attach the prefilter.
Upper left tab (1 location)
(The upper left tab is shaped
differently from the others.)
Prefilter
Attach the front panel.
Top hooks (2 locations)
Top grooves
(2 locations)
Front panel
[View from above]
X
Page 16.
If the front panel is improperly set, the safety switch
may be activated. Operation may not start.
Attach
Prefilter
• Hold the indent and pull the prefilter. Then, unhook the
tabs (4 locations) of the prefilter from the holes (2 each on
the right and left) of UNIT1.
• Holding UNIT1 by the handles, pull UNIT1 upward and
remove it.
• Holding the deodorising catalyst unit by the handles, pull
the deodorising catalyst unit upward and remove it.
• Holding the deodorising catalyst unit by the handles, pull
the deodorising catalyst unit upward and remove it.
1) Fasten the
hooks.
2) Press the front panel until
you hear clicking sound.
• Fasten the top hooks (2 locations) of the front panel to the
top grooves (2 locations) of the main unit and then close
the front panel.
2) Press the deodorising catalyst unit
until you hear clicking sound.
• Push the 2 clips (right and left), and pull the front panel
upward and remove it.
• Holding the deodorising catalyst unit by the handles, fit the
projections into the grooves (4 locations) at the bottom of
the main unit and, press the deodorising catalyst unit into
the main unit.
• Holding UNIT1 by the handles, fit the projections into the
grooves (2 locations) at the bottom of the main unit, and
press UNIT1 into the main unit.
2) Press UNIT1 until you
hear clicking sound.
• Fit the tabs (4 locations) of the prefilter into the holes
(2 each on the right and left) of UNIT1.
