Operation Manual
SiBE811120
26
Photocatalytic Air Purifier L-Series
4.8
Cleaning of UNIT1 and UNIT2
UNIT1
(Plasma ioniser)
UNIT2
(Streamer unit)
19
Cleaning of UNIT1 and UNIT2
Soak, drain and dry
Wipe
X
Page 17.
Procedure
UNIT1
Remove the parts.
X
Page 17, 18.
X
Page 18.
Wipe
Rub
Rinse in running water and drain.
Attach the parts.
X
Page 17, 18.
X
Page 18.
1) Ionising frame
(Remove dirt after soaking but before drying.)
Soak in lukewarm water or water.
(About 1 hour)
2) Ionised wire (rear)
1) Ionising frame
4) Streamer unit
1) Ionising frame
2) Ionised wire
3) Opposing pole plates
Use a vacuum cleaner to remove the
dust.
Remove dirt with a piece of cloth, soft
brush, etc.
Wear rubber
gloves.
Dry in a well-ventilated, shaded
place. (About 1 day)
• Remove dirt from plastic parts with a soft piece of cloth.
• Use a cotton swab, etc. to wipe away dirt in recesses and places where fingers do not fit.
• Do not leave any lint from cleaning cloths behind. Lint may lead to malfunctions.
* Remove dirt from recesses
with a cotton swab, etc.
Wear rubber
gloves.
Wear rubber
gloves.
Wear rubber
gloves.
For details, see 1) and
2) below.
3) Opposing pole
plates
Time for
cleaning
Cleaning
method
UNIT1:
If
the “UNIT1” lamp lights
UNIT2:
Once every 3 months or if
the “UNIT2” lamp lights
If marking is a concern, clean the unit even if the “UNIT1” and “UNIT2”
lamps do not light.
For details on removing and attaching each part,
see .
