Operation Manual
SiBE811120
28
Photocatalytic Air Purifier L-Series
4.9
Replacement of the Pleated Filter
21
X
Page 17.
X
Page 17.
Replacement of the Pleated Filter
Replace
Pleated filter
Front panel
UNIT1
Deodorising
catalyst unit
1
Remove the front panel and UNIT1.
3
Attach UNIT1 and the front panel.
4
Connect the power plug.
(The filter lamp goes off with a short beep sound.)
Filter reset button
NOTE
Options
ATTENTION
• For replacement pleated filters contact the service shop.
Disposal requirements
Model
Part
Pleated filter (7)
KAC017A4E
Time for
cleaning
Cleaning
method
When the filter lamp in the
display lights up or blinks
It is not necessary to replace the pleated filter
until the filter lamp lights up or blinks.
2
Replace the pleated filter with a new
filter.
1) Remove the used pleated filter.
• Release the pleated filter from the projections
(5 each on the right and left) of the deodorising catalyst
unit (front side).
2) Take out a new pleated filter from the filter
container and then attach it to the deodorising
catalyst unit.
• Fit the holes (5 each on the right and left) of the
pleated filter onto the tabs on the right and left of the
deodorising catalyst unit.
• Insert the pleated filter underneath the tabs
(4 locations at the top and bottom) of the deodorising
catalyst unit.
Projection
(5 each on right and left)
Pleated filter
Top and
bottom tabs
(4 locations)
Deodorising
catalyst unit
Face the white
side to the front.
5
Press the filter reset button on the upper
part of the front panel for 5 seconds.
• Even if the pleated filter is replaced, the filter lamp does not
go off unless you press the filter reset button for 5 seconds.
• Order the pleated filter for replacement from your dealer.
• Replace the pleated filter when the filter lamp lights up or blinks
even if the filter looks clean. The amount of visible dirt does not
represent the capacity of the filter.
• The replacement interval for the pleated filter varies according to
how the unit is used and where it is located.
The filter lamp lights up after about 2 years if the unit is used
every day in a house where 10 cigarettes per day are smoked.
(The replacement interval shortens when the unit is used where
the air is particularly dirty.)
• When you have replaced the pleated filter before the filter lamp
lights up because of visible dirt or generation of odour, press the
filter reset button for 5 seconds.
• If the unit is used with dirty parts
• Air is not cleaned.
• Odors are not removed.
• Unnecessary odors may be generated.
• Discard of the pleated filters as noncombustible waste.
Your product and the batteries supplied with the controller
are marked with this symbol. This symbol means that
electrical and electronic products and batteries shall not
be mixed with unsorted household waste.
For batteries, a chemical symbol can be printed beneath
the symbol. This chemical symbol means that the battery
contains a heavy metal above a certain concentration.
Possible chemical symbols are:
Pb: lead (>0.004%)
Hg: mercury (>0.0005%)
Disposal of this product must be done in accordance with relevant
local and national legislation.
Units and waste batteries must be treated at a specialized
treatment facility for re-use, recycling and recovery.
By ensuring correct disposal, you will help to prevent potential
negative consequences for the environment and human health.
Please contact the installer or local authority for more information.
