SiBE811120
Operation Manual
Photocatalytic Air Purifier L-Series
17
10
4
Attach the pleated filter.
Make sure to set the prefilter (green) and the pleated filter
(front: white, rear: blue) in place.
If you operate the unit without them, the unit may be
damaged.
1) Fit the holes (5 each on the right and left) of the pleated
filter to the fixing lugs (5 each on the right and left) of the
deodorising catalyst unit.
Projection
(5 each on right and left)
Pleated filter
Holes
(5 each on right and left)
Face the white
side to the front.
Deodorising catalyst unit
2) Insert the pleated filter underneath the tabs (4 locations)
at the top and bottom of the deodorising catalyst unit.
Top and bottom
tabs (4 locations)
• Unit performance drops if the pleated filter is attached
backward.
5
Attach the deodorising catalyst unit.
• Holding the deodorising catalyst unit by the handles, fit the
projections into the grooves (4 locations) at the bottom of
the main unit and press the deodorising catalyst unit into
the main unit.
Handles
1)
Fit here.
Deodorising catalyst unit
2) Press the deodorising
catalyst unit until you
hear clicking sound.
6
Attach UNIT1.
• Holding UNIT1 by the handles, fit the projections into the
grooves (2 locations) at the bottom of the main unit, and
press UNIT1 into the main unit.
Handles
UNIT1
1)
Fit here.
2) Press UNIT1 until you
hear clicking sound.
7
• Fasten the top hooks (2 locations) of the front panel to the
top grooves (2 locations) of the main unit and then close
the front panel.
Top grooves
(2 locations)
Top hooks
(2 locations)
1) Fasten the hooks.
Front panel
[View from above]
2) Press the front panel
until you hear clicking
sound.
If the front panel is improperly set, the safety switch
may be activated. Operation may not start.
Page 16.
Attach the front panel.
