D-Link DGS-1210/ME series, Справочное руководство

Страница: 481 / 522

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
461
62
LACP COMMANDS
The LACP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameter
config lacp port_priority <portlist> <value 0-65535> [timeout <long | short>]
show lacp {<portlist>}
config lacp_ports <portlist> mode [active | passive]
Each command is listed in detail, as follows:
config lacp port_priority
Purpose To set the priority value of a physical port in an LACP group.
Syntax
config lacp port_priority <portlist> <value 0-65535> [timeout
<long | short>]
Description The config lacp port_priority command sets the LACP priority
value and administrative timeout of a physical port or range of ports
in an LACP group.
Parameters <portlist> - A port or range of ports to be configured.
<value 0-65535> - Specifies the LACP priority value for a port or
range of ports to be configured. The default is 1.
<timeout> - Specifies the administrative LACP timeout.
•
long – Specifies the LACP timeout to be 90 seconds. This is
the default.
•
short – Specifies the LACP timeout to be 3 seconds.
Restrictions Only Administrator or operator-level users can issue this command.
Example usage:
To configure the LACP priority of ports 1-3:
DGS-1210-28MP/ME:5# config lacp port_priority 1-3 100 timeout long
Command: config lacp port_priority 1-3 100 timeout long
Success.
DGS-1210-28MP/ME:5#
show lacp
Purpose To display current LACP port mode settings.
Syntax show lacp {<portlist>}
Description
The show lacp command displays the current LACP mode settings.