CyberOptics SE500ULTRA, Руководство по оборудованию

Страница: 114 / 188

Chapter 3 : Replacing Components and Preventive Maintenance
104 SE500
ULTRA
Hardware Manual
Replacing the Conveyor Belts
Use this procedure to replace the conveyor belts on the fix or the rear railsets. This procedure
can be performed with access to the left/right of the machine in production line. This section
shows the procedure performed when the machine is not in production line.
Parts
Edge Belt
Required Tools
– No. 2.5 Allen Key
– No. 3 Allen Key
– Threadlock Sealant
➢
To replace conveyor belt
1. Make sure the sensor is at the HOME position without blocking any portion of the rail.
2. Make sure the Clamp Blade at the rails are in the “OPEN” position.
3. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 52.
4. Open the front cover from the machine.
5. Loosen the Idler pulley No. 2 by using the No. 3 Allen Key at the setscrew.
6. Slide the Idler pulley towards the motor direction in order to relieve the belt tension.
Figure 57. Conveyor Belt Replacement
7. Loosen the belt from the drive pulley first followed by the sequence pulley No. 3 & 5.
8. Make sure the belt is loosen from the both ends.
9. Remove the belt from the drive pulley.
10. Route the new belt following the sequence starting at pulley No. 1, followed by pulley No. 2,
pulley No. 3, pulley No. 4, drive pulley, pulley No. 5 and lastly pulley No. 6 as shown in
Figure 57.
11. Push the Idler pulley No. 3 at 6kgf by using the Push-Pull gauge.
12. Tighten the setscrew to pulley No. 3 after applying adequate amount of threadlocking
sealant.
i
Note: For Parts Replacement, contact CyberOptics for part numbers.
Pulley 1
Pulley 2
Pulley 3
Pulley 4
Pulley 5
Pulley 6
Railset
Drive pulley