CyberOptics SE500ULTRA, Руководство по оборудованию

Страница: 37 / 188

CyberOptics Corporation 27
Installing the System
Installing the System
Installing the SE500
ULTRA
system consists of the general steps listed below. Each step is
described in more detail on the following pages.
●
“ Installing the Light Pole ” on page 27
●
“ Positioning / Leveling the SE500ULTRA ” on page 28
●
“ Installing the Sensor ” on page 32
Installing the Light Pole
➢
To install the light pole
1. Loosen and remove two spring loaders along the upper rear panel to remove the panel from
the system.
2. Remove the attaching nut from the light pole and slide it off of the cable.
3. Place the light pole in an upright position and insert the threaded end of the pole into the
hole on top of the enclosure.
4. Tighten the bolt inside the enclosure so that the light pole is firmly attached to the unit.
5. Connect the light pole cable to the available cable connector that is tied to the frame.
6. Replace the rear panel.
Figure 12. Light Pole Installation
Caution:
The SE500
ULTRA
is a precision measurement system. To ensure optimum performance
of your SE500
ULTRA
, a trained CyberOptics service representative is required to install the
system.
Slide nut onto cable and
tighten underneath frame
Connect light pole cable to
cable inside frame