CyberOptics SE500ULTRA, Руководство по оборудованию

Страница: 55 / 188

CyberOptics Corporation 45
Setting Up System Security
Setting Up System Security
The SE500
ULTRA
software contains a security feature used to control access to certain features.
SE500
ULTRA
security applies a system of Groups and Users to determine which logon names can
access a given function. The default security setup includes the following groups:
●
Supervisors
●
Engineers
●
Lead Operators
●
Operators
The default security system includes the following user logons:
●
Supervisor
●
Engineer
●
Lead Operator
●
Operator
Anyone using the SE500
ULTRA
can use one of the default logons (password CyberOptics ). The
default setup allows full access to all SE500
ULTRA
features for all users except for the Security
Setup feature. Only the Supervisor logon has rights to change the Security Setup by default.
The default setup also includes an Auto logon feature, so that when any of the default system
logons are used, a separate SE500
ULTRA
logon is not required.
If you are logged on as a Supervisor (or user with Supervisor rights) you can change the
security setup at any point to allow access to certain features depending on the system logon.
For more information about assigning access, refer to pages “
Assigning Secure Areas ” on page 48
and “ To assign access to groups ” on page 49.
i
Note:
The order of the groups listed above is from the most to least privileged and always
include all lower level privileges.
i
Note: If the security feature is not a requirement in your facility, use the default logons for the
least amount of setup.