Crystal Vision
The card edge display
TANDEM-110 User Manual R1.8
54
07/07/2010
Selecting sources and destinations
This menu, obtained with Menu lever 4 ON (DOWN), is used to select the source for each
destination available on the board. The destination is selected using the SEL switch whilst
the source and its delay and phase setting is selected using the ADJ shaft encoder. Save
each source assignment by toggling MENU switch 1 down and then up again.
SEL
No.
Sources
Source description
ADJ selects source
Further ADJ rotation
selects delay/phase
Dest
Dest description
SEL selects dest
0 - 3
G1 - G4
Audio from input
option on side 1
> Normal phase
D> Delay assigned
/ Inverted Phase
D/ Delay + inversion
C1 - C4 Audio embedded
into side 1 SDI
4 - 7
H1 – H4
Audio from input
option on side 2
> Normal phase
D> Delay assigned
/ Inverted Phase
D/ Delay + inversion
D1 - D4
Audio embedded
into side 2 SDI.
8 – B
A1 – A4
Audio de-
embedded from
SDI side 1
> Normal phase
D> Delay assigned
/ Inverted Phase
D/ Delay + inversion
I1 - I4
Output option
card on side 1
C - F
B1 – B4
Audio de-
embedded from
SDI side 2
> Normal phase
D> Delay assigned
/ Inverted Phase
D/ Delay + inversion
J1 - J4
Output option
card on side 2
Notes:
The source and destination codes are the same as used in status displays except that ‘I’
and ‘J’ will be replaced by ‘E’ and ‘F’, respectively, if no option card is fitted, to
indicate that no outputs exist, except via the audio monitor function.
Unavailable destinations are followed by [no] in the display.
Routing must involve either an embedder and an input card or a de-embedder.
Routing between sides is not supported and audio routing directly from a de-embedder
to an embedder (i.e. A1 > E1 or B2 > F2) is NOT supported by TANDEM-110, even
though such assignments may be displayed at the card edge.
Assigning delay and phase inversion
When a source has been chosen for each destination during audio routing, it is possible to
set the audio processing options by further rotation of the ADJ shaft encoder. The
available options are delay, phase inversion, delay plus phase inversion and normal.
Notes:
The value of the delay assigned to each side using sub-menus C and D of the Status
Menu.
