Crystal Vision
The active control panel
TANDEM-110 User Manual R1.8
40
07/07/2010
Example 2
To de-embed audio from Group 3, Sdi 2, channel 3 and route it to channel 3 of an
analogue output option on side 2 proceed as follows:
Select input group 3 with menu 1.2.2 for side 2
Menu 1.2.2 shows:
Control Side2 Mux
AG in 3 AG out 2
F2 F4
Ensure Audio Group in is set to 3. Press
F2
and rotate
shaft encoder
until
AG in 3
is
displayed. (Remember to press Enter to save group selection.)
Select desired destination (Aop2 Ch3) and source (Dmx2 Ch3) with menu 1.2.4
Menu 1.2.4 shows:
Assign Audio Routing
Sdi1 Aop2
F1 F4
Press F4 to bring up destination (Aop2) routing for Channels 1-4 for side 2
Menu 1.2.4.4 shows:
OP Option 2 Routing
Ch1 Ch2 Ch3 Ch4
F1 F2 F3 F4
Press F3 to bring up source/delay select for the channel 3, OP option, side 2
Menu 1.2.4.4.3 shows:
Dmx2Ch3 > Opt2 Ch3
Acc Alter with Knob
F1
Use shaft encoder to select source channel from De-embedder(Dmx) on side 2, further
rotation selects delay/phase inversion for the chosen route
Press F1 (Acc) to accept the displayed route and phase/delay
If delay but no phase inversion had been required, routing display should be:
Dmx2Ch3 D> Opt2 Ch3
Acc Alter with Knob
