Crystal Vision
The active control panel
TANDEM-110 User Manual R1.8
41
07/07/2010
Assigning mono/stereo options
If an input card is fitted, the mono function follows the router and any of the four output
channels can be set as the mono sum of its stereo pair. If an output card is fitted, the mono
function precedes the router and input channels 1&2 and input channels 3&4 can be
configured as either a stereo or mono source.
The following menus are obtained by pressing F4 (Mono) from the Cntl > Asgn menu and
rotating the shaft encoder control to display the sub-menus appropriate for the option
cards fitted on each side and the audio channel pairs. Press F1 to sum the channels
selected or F2 to restore them as individual channels.
Select mono options
Description
This menu will be available for any side with an embedder
present (ie input card fitted)
Chan-> indicates that the shaft control is active, and will
select side/router channels
Press F1, 'Mono' to change the display to 'embed mono'
Press F2, 'Not Mono' to return the display to 'embed chan'
This menu will be available if an output card is fitted
Chan-> indicates that the shaft control is active, and will
select side/router channels
Press F1, 'Sum' to change the display to 'summed'
Press F2, 'Not Sum' to return the display to 'not summed'
If no input card fitted on side 2, the display will read:-
SDI2 no embedder
If no output card is fitted on side 1, the display will read
No Op card side 1/2
Note:
SDI1, SDI2 and option card mono channels are all selected by the shaft control from the
mono menu.
If any menus shown here are not available, then the option cards fitted do not support
those functions. The display will always indicate if an input card (embedder function) or
output card is not fitted.
