Crystal Vision
The active control panel
TANDEM-110 User Manual R1.8
38
07/07/2010
Assigning audio routing, phase and delay
Assign Audio Routing
Description
Audio routing: destinations depend on options fitted
F1 = Sdi 1 – if input option fitted on side 1
F2 = Sdi 2 – if input option fitted on side 2
F4 = Aop/Dop – if output option fitted on side 1
F4 = Aop/Dop – if output option fitted on side 2
‘Destination’ may be Embedder1, Embedder 2, OP Option 1
or OP Option 2
Select appropriate ‘F’ button to route to audio channels 1-4
Select ‘source’ with shaft encoder to route to ‘destination’
and ‘channel’ chosen in previous menu
Source may be Dmx1, Dmx2, Opt1, Opt2
Destination may be Mux1, Mux2, Opt1, Opt2
Shaft encoder also selects Delay (D), Inversion (/) and
Normal (>)
Notes:
Audio assign menus, (1.2.4.1.1-4.1-4) may be used as a status display to read current
audio routing assignments using providing F1 (Acc) is not pressed.
Use F1 to cycle through delay and/or phase inversion choices.
Delay and phase codes:
The following codes are used for delay and phase inversion
>
D>
/
D/
Normal phase and no delay
Delay
Inverted Phase
Delay + inversion
Tip:
If TANDEM-110 firmware or sub-boards have been changed it is recommended to start
by loading valid default settings for the entire routing table held in TANDEM’s non-
volatile memory. This will prevent erroneous settings from appearing in the routing
assignment menus. From firmware V5.15 this function is performed automatically (card-
edge display shows Save Pre15 > Pre1). . This facility is only available from the card
edge – (Defaults: Lever 6 DOWN, SEL switch = B) - please refer to section 5.2 for
further details. Always check that the appropriate groups are selected for embedding or
de-embedding after loading defaults (section 5.3 for card edge controls).
Note:
Routing with the TANDEM-110 must involve either an embedder and an input card or a
de-embedder and an output card. Routing between sides is not supported.
