Crystal Vision TANDEM-100, Руководство пользователя

Страница: 51 / 104

Crystal Vision
The card edge display
TANDEM-110 User Manual R1.8
50
07/07/2010
Status/Config menus
WARNING: For the first five SEL status positions the shaft encoder is not active and
settings cannot be changed, for SEL positions 6 to F, the shaft encoder will alter (but not
save) the assigned values as indicated in the remainder of the table. Do
NOT touch the
ADJ shaft encoder when using these SEL positions for status information.
SEL
No.
Description Examples and comments ADJ funct
6 SD 1 de-embed
audio group A=Agroup= n , where n is -(no group) or 1,2,3,4.
Shaft encoder changes value of n
ADJ= n
7 SD 2 de-embed
audio group B=Bgroup=n, where n is -(no group) or 1,2,3,4.
Shaft encoder changes value of n ADJ= n
8 SD 1 embed audio
group C=Agroup=n, where n is -(no group) or 1,2,3,4.
Shaft encoder changes value of n ADJ= n
9 SD 2 embed audio
group D=Bgroup=n, where n is -(no group) or 1,2,3,4.
Shaft encoder changes value of n ADJ= n
A Audio bus settings
for audio monitor AUDbus=OFF or AN. ADJ=
ON/AN
B Audio monitor
source Selects stereo source for headphone socket and
rear audio monitoring bus if enabled
Amon = XX XX, where XX XX indicates the
stereo pair monitored ADJ=
stereo pair
select
C Audio delay side 1 Set using ADJ shaft encoder in 1ms steps from
1 – 681ms ADJ=
delay
D Audio delay side 2 Set using ADJ shaft encoder in 1ms steps from
1 – 681ms ADJ=
delay
E Silence threshold Set using ADJ shaft encoder for the delay time
(DL) in seconds after which a channel is
considered silent (< -50dB wrt Full Scale).
Available values start at 1.5s, 8s and then in
increments of 8s until 120s ADJ=
threshold
F
GPI Enable/Disable Disables General Purpose Inputs. General
Purpose Outputs (GPOs) are not disabled ADJ=
disable
/enable
Notes:
Remember that the ‘=’ sign before a group number indicates an existing group.
Audio routing is described in detail in section 5.3. Audio monitoring is described in
section 5.5 and GPI enable/disable options are described in section 5.6.
Ancillary data status
The ancillary data status display is obtained with Menu lever 6 ON (DOWN), all other
levers UP (OFF
) and the SEL switch in position E for side 1 and F for side 2.
SEL Display Comments
E
SD1 1234dE See section 5.7 for a detailed explanation
F SD2 1234dE