Crystal Vision
The active control panel
TANDEM-110 User Manual R1.8
39
07/07/2010
Routing assignment examples
As explained in the Introduction chapter, there are three configurations available. These
are dual de-embedder, dual embedder or a mixed embedder/de-embedder. Audio can be
routed in the following ways:
Embedding
Route any channel from an audio input sub-module to any group within
the embedder on the same side
De-embedding
Route de-embedded audio channel from any group within the input SDI
bit stream to an audio output sub-module on the same side
Delay
Delay and phase inversion may be applied independently on each side
Example 1
To embed audio from channel 1 from an input option on side 1 into channel 2 of SDI 1,
Group 2, proceed as follows:
Select output group 2 with menu 1.2.1 for side 1
Menu 1.2.1 shows:
Control Side1 Mux
AG in 1 AG out 2
F2 F4
Ensure Audio Group out is set to 2. Press
F4
and rotate
shaft encoder
until
AG out 2
is displayed. (Remember to press Enter to save group selection.)
Select desired destination (Sdi 1 Ch2) and source (Opt1 Ch1) with menu 1.2.4
Menu 1.2.4 shows:
Assign Audio Routing
Sdi1 Aop2
F1 F4
Press F1 to bring up destination (Embedder) routing for Channels 1-4 for side 1
Menu 1.2.4.1 shows:
Embedder 1 Routing
Ch1 Ch2 Ch3 Ch4
F1 F2 F3 F4
Press F2 to bring up source/delay select for Embedder(Mux) 1, Channel 2
Menu 1.2.4.1.2 shows:
Opt1Ch1 > Mux1 Ch2
Acc Alter with Knob
F1
Use shaft encoder to select source channel from Input Option on side 1, further rotation
selects delay/phase inversion for the chosen route
Press F1 (Acc) to accept the displayed route and chosen phase/delay
If delay and phase inversion had been required, routing display should be:
Opt1Ch1 D/ Mux1 Ch2
Acc Alter with Knob
