Comtech EF Data LPOD-R PS .5, Инструкция по установке и эксплуатации

Страница: 78 / 152

LPOD-R Outdoor Amplifier / Block Up Converter (BUC) MN-LPODR
Firmware Update Revision 3
3–14
2. Enter your upload parameters information into CReflash:
a. Left-click in the “IP Address:” text box, and enter the default
Management IP Address (e.g., 192.168.1.4).
b. Left-click in the “Local Filename:” text box. Then, click [Browse]
and navigate to the temporary folder created earlier. Click on the
firmware “BIN” filename, and then click [Open] . The filename will
appear in the “Local Filename:” text box.
c. Make sure the drop-down list remains set to “ bulk: ”.
d. Click [Start] to begin the upload process. If the information was
correctly entered into CReflash, the utility displays an animated
progress bar at the bottom of the window, along with a series of
messages:
•
“Opening FTP”
•
“Sending data file to modem:”
•
“Writing FLASH: # of #”
•
“Success!”
3. When done, click [Cancel] to exit CReflash.
3.4.3 Steps to FTP Upload the Firmware Files
1) Typical for all steps: “xxx.xxx.xxx.xxx” represents the assigned unit
Management IP Address.
2) Type all commands without quotes, and press Enter to execute.
1. To proceed, you should already have noted the Management IP Address for
the LPOD-R as instructed in Section 3.2.3.
2. Use Windows Command-line to send a ping command. To ping the unit, type
“ping xxx.xxx.xxx.xxx” at the Windows Command-line prompt. The response
should confirm whether the unit is connected and communicating correctly
with the User PC.