Comtech EF Data LPOD-R PS .5, Инструкция по установке и эксплуатации

Страница: 129 / 152

LPOD-R Outdoor Amplifier / Block Up Converter (BUC) MN-LPODR
Optional Serial Interface Operation (PS 1, PS 1.5 ONLY) Revision 3
5–25
Parameter Type
(* indicates
End-of-Life)
Controller-to-Target
Instruction Code and
Qualifier
Arguments for
Command or
Response to
Query
Description of Arguments
(Note that all arguments are ASCII numeric codes from 48 to 57)
Target-to-Controller
(see Description of Arguments)
Command Query
Response to
Command
Response to
Query
Terminal Status
Change
N/A TSC? 1 byte Query only.
Indicates if there has been a change in the configuration since the last time the command was given, in the form
x, where:
0 = No status change.
1 = Status change has occurred.
NOTES:
1) A “status change” is defined as any time a parameter is changed, e.g., when a command is successfully
executed that changes a value. A status change also results when there is a fault condition.
2) A query does not set the status change flag. The status change flag is cleared after being read.
EXAMPLE: <0001/TSC?{CR}
>0001/TSC=0{CR}{LF}
TSC= TSC=x
Time Protocol
Enable
TPE= TPE?
1 byte,
numerical
Command or Query.
Sets or returns Time Protocol in the form x, where:
0 = Disable
1 = Enable
COMMAND EXAMPLE: <0001/TPE=1{CR} (Enables Time protocol)
TPE=
TPE?
TPE=x
Time Protocol
Server
TPS= TPS?
15 bytes,
alphanumeric
Command or Query.
Sets or returns the Time Server IP Address for the unit’s Tx Ethernet management port, in the form
xxx.xxx.xxx.xxx.
NOTE: Default Value = 255.255.255.255
COMMAND EXAMPLE: <0001/TPS=192.168.001.005{CR}
TPS=
TPS?
TPS=xx.xxx.xxx.
xxx