Comtech EF Data LPOD-R PS .5, Инструкция по установке и эксплуатации

Страница: 112 / 152

LPOD-R Outdoor Amplifier / Block Up Converter (BUC) MN-LPODR
Optional Serial Interface Operation (PS 1, PS 1.5 ONLY) Revision 3
5–8
5.4 Remote Commands and Queries
Certain commands and queries are marked as End-of-Life (EOL). These features (noted with * in the Parameter Type field) are fully
supported in this product; however, Comtech EF Data strongly recommends that you use the equivalent new command or query for
new implementations. The “Description of Arguments” section of the replacement command or query notes its status for the
affected EOL feature.
Attenuation, 5–9
Auto Fault Recovery, 5–9
Circuit Identification, 5–11
Clear All Stored Alarms, 5–9
Clear All Stored Events, 5–9
Clear Trending Data, 5–12
Concise Alarm Status, 5–10
Concise Configuration Status, 5–11
Concise Maintenance Status, 5–12
Concise RF Power FET Current Status, 5–11
FSK Address, 5–22
Gateway IP Address, 5–15
Global Amplifier Configuration, 5–14
Heatsink Temperature, 5–24
Initialize Events Pointer, 5–14
Initialize Statistics Pointer, 5–15
Low Forward Power Threshold, 5–16
MAC Address, 5–16
Management IP Address, 5–15
Mute State, 5–16
Number of Unread Events, 5–16
Number of Unread Statistics, 5–17
Part Number, 5–17
Reboot Command, 5–18
Remote Address, 5–23
Retrieve Alarm Status, 5–17
Retrieve Configuration Status, 5–18
Retrieve Equipment Type, 5–18
Retrieve Firmware Number, 5–13
Retrieve Maintenance Status, 5–20
Retrieve Next 5 Events, 5–21
Retrieve Next 5 Statistics, 5–22
Retrieve next 5 unread Stored Alarms, 5–15
Retrieve Number of unread Stored Alarms*, 5–
24
RF Power Amplifier State, 5–9
RF Power FET Current status, 5–19
Serial Number, 5–22
Serial Number*, 5–23
Set Physical (remote) Address, 5–23
Set RTC Date (by Day), 5–12
Set RTC Date (by Month)*, 5–12
Set RTC Time, 5–24
SNMP Authentication Trap Enable, 5–22
SNMP Enable, 5–23
SNMP Read Community, 5–23
SNMP System Contact, 5–23
SNMP System Location, 5–23
SNMP Trap Destination IP Address 1, 5–23
SNMP Trap Destination IP Address 2, 5–24
SNMP Trap Version, 5–24
SNMP Unit Name, 5–23
SNMP Write Community, 5–24
Software Image Selection, 5–14
Software Revision, 5–24
Statistics Averaging, 5–13
Statistics Interval, 5–23
Summary Fault Status, 5–22
Terminal Status Change, 5–25
Time Protocol Enable, 5–25
Time Protocol Serve, 5–25
Unit Alarm Mask, 5–16