Citrix ByteMobile T1010, Установка, настройка и администрирование

Страница: 89 / 172

T-Series Traffic Director Installation, Configuration and Administration Guide 3-15
Configuring T1000 Data Plane for Layer-2 and Layer-3
Ingress VLANs are configured on the appropriate ports communicating with wireless router
and OSN ingress interfaces. Using the example configuration:
> add vlan 100
Done
> add vlan 151
Done
> bind vlan 100 -ifnum LA/1 -tagged
Done
> bind vlan 151 -ifnum 10/3 -tagged
Done
Egress VLANs are configured on the appropriate ports communicating with internet router
and OSN egress interfaces. Using the example configuration:
>
add vlan 200
Done
> add vlan 251
Done
>
bind vlan 200 -ifnum LA/1 -tagged
Done
> bind vlan 251 -ifnum 10/4 -tagged
Done
Configuring IP Addresses
Refer to “Assigning VLANs, IP Addresses, and Ports” on page 3-4 for information on how
to assign IP addresses. The T1000 requires one or more Subnet IP addresses (SNIPs). A
Subnet IP enables the T1000 to connect to a subnet which is different than that of the NSIP
address. For the sample network in Figure 3-2, four (4) SNIPs must be configured in T1000
in order to connect to the four subnets (wireless side, osn ingress side, osn egress side,
internet side).
Use the add ns ip command as follows to configure IP addresses:
add ns ip IPAddress netmask -vServer DISABLED
Using the example configuration:
> add ns ip 172.16.112.101 255.255.255.0 -vServer DISABLED
Done
> add ns ip 169.254.0.100 255.255.255.0 -vServer DISABLED
Done
> add ns ip 169.254.64.100 255.255.255.0 -vServer DISABLED
Done
> add ns ip 172.16.113.101 255.255.255.0 -vServer DISABLED
Done
Binding VLANs to IP Addresses
After configuring the VLANs and IP addresses, you must bind the VLANs to the IP
addresses.
Use the bind vlan command with the following syntax to bind VLAN IDs to IP addresses:
bind vlan id -IPAddress ip_addr netmask
Using the example configuration: