Citrix ByteMobile T1010, Установка, настройка и администрирование

Страница: 62 / 172

2-22 T-Series Traffic Director Installation, Configuration and Administration Guide
Chapter 2 Installing the T1000
Turning On AC Power to the System
The T1000 unit has a power switch located on the rear panel. See Figure 2-8 above. When
properly energized, the LCD panel on the front of the T1000 will illuminate.
Turning Off AC Power to the System
If you need to shut down the T1000 to move it or to perform maintenance, you must make
sure all the processes in the system are shut down properly.
Follow the steps below to power off the system:
Step 1 Log on to the system CLI or GUI and access the shutdown function to power-off the T1000.
All processes are shut down gracefully before power to the T1000 is switched off.
Step 2 Turn off AC power to the circuits that are providing power to the T1000.
Step 3 Disconnect the power cables from the rear of the T1000. See Figure 2-8.
Connecting and Disconnecting DC Power
Attention: Only trained service personnel other than Bytemobile service technicians are
authorized to install and remove the -48 volt DC power supply, and make the
connections to and disconnections from the -48 volt DC power source.
Bytemobile service technicians are not certified or authorized to install or
remove the -48 volt power cable. The customer is responsible for ensuring that
only trained service personnel install or remove the -48 volt power cable.
This section describes how to connect and disconnect power to a T1000 shelf configured
with DC power. This section has the following topics:
• “Before you Begin DC Power Connection” on page 2-23
Caution: Statement 5:
The power control button on the T1000 does not turn off the electrical current
supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are
disconnected from the power source.
1
2