Citrix ByteMobile T1010, Установка, настройка и администрирование

Страница: 55 / 172

T-Series Traffic Director Installation, Configuration and Administration Guide 2-15
Making Data Plane Connections
Step 5 Insert the DAC connector into the SFP port until it clicks into place. See Figure 2-6. To
avoid damage to DAC, follow these guidelines:
• Leave enough slack in the cable so that it does not bend to a radius of less than 25
mm (1 in.) when components or cables are moved or shifted.
• Route the cable away from places where it can be snagged by other devices in the
rack.
• Do not overtighten the cable straps or bend the cables to a radius of less than 25 mm
(1 in.).
• Do not put excess weight on the cable at the connection point. Make sure that the
cable is well supported.
To remove the DAC, complete the following steps:
Step 1 Grasp the release tab on the DAC and gently pull the DAC from the port.
Step 2 Protect the unconnected end of the DAC, or the entire DAC, by placing it in a static
protective package.
Step 3 Replace the protective cap on the SFP port.
Using a Fiber Cable and Transceiver
The fiber transceiver module is a hot-pluggable unit, meaning that it can be installed and
removed at any time while the unit is operational. The module provides two fiber-optic
cable connectors for connecting to external ports.
To install the module and cables, complete the following steps:
Step 1 Review the guidelines in “SFP/SFP+ Port and Cable Installation Guidelines” on page 2-14.
Step 2 Remove the protective cap from the SFP port on the T1000, and store the cap in a safe place.
Step 3 Touch the static-protective package that contains the transceiver module to an unpainted
metal surface of the shelf or an unpainted metal surface on any other grounded rack
component in the rack in which you are installing the module for at least 2 seconds.
Step 4 Remove the transceiver module from its static-protective package and store the package in a
safe place.
Danger:
Fiber Optic Hazardous Radiation (Fiber Optic Statement 1)
Fiber optic products use laser radiation with the potential to cause injury. Uncovered
ports may release this radiation. Avoid direct exposure to laser radiation. Do not stare
into the beam, and do not view directly with optical instruments. Do not remove any
protective shields on fiber optic transceiver modules.