Citrix ByteMobile T1010, Установка, настройка и администрирование

Страница: 56 / 172

2-16 T-Series Traffic Director Installation, Configuration and Administration Guide
Chapter 2 Installing the T1000
Step 5 Insert the transceiver module into the SFP port until it clicks into place. See Figure 2-6.
Step 6 Remove the protective caps from the end of the fiber optic cable.
Step 7 Gently slide the fiber optic cable into the port on transceiver module until it clicks into
place. See Figure 2-6. To avoid damage to fiber optic cables, follow these guidelines:
• Do not route the cable along a folding cable-management arm.
• Leave enough slack in the cable so that it does not bend to a radius of less than 38
mm (1.5 in.) when components or cables are moved or shifted.
• Route the cable away from places where it can be snagged by other devices in the
rack.
• Do not overtighten the cable straps or bend the cables to a radius of less than 38 mm
(1.5 in.).
• Do not put excess weight on the cable at the connection point. Make sure that the
cable is well supported.
To remove the module and cables, complete the following steps:
Step 1 Squeeze the release tabs and gently pull the fiber optic cable from the transceiver module.
Step 2 Replace the protective caps on the ends of the fiber optic cable.
Step 3 Unlock the transceiver module by pulling the wire handle straight out.
Step 4 Grasp the wire handle and pull the transceiver module out of the port.
Step 5 Replace the protective caps on the transceiver module and the SFP port.
Step 6 Place the transceiver module into a static-protective package.
Using an Ethernet Cable and Transceiver
The Ethernet transceiver module is a hot-pluggable unit, meaning that it can be installed and
removed at any time while the unit is operational. The module provides a standard RJ-45
port.
To install the module and cables, complete the following steps:
Step 1 Review the guidelines in “SFP/SFP+ Port and Cable Installation Guidelines” on page 2-14.
Step 2 Remove the protective cap from the SFP port on the T1000, and store the cap in a safe place.
Step 3 Touch the static-protective package that contains the transceiver module to an unpainted
metal surface of the shelf or an unpainted metal surface on any other grounded rack
component in the rack in which you are installing the module for at least 2 seconds.
Step 4 Remove the transceiver module from its static-protective package and store the package in a
safe place.
Step 5 Insert the transceiver module into the SFP port until it clicks into place. See Figure 2-6.