IP Dual Port PBXgateway and Remote System Administrator’s Guide
56
Advanced System Parameters – System Settings
The Remote system configuration screen is shown below:
Path:
Remote->Configuration->System
Figure 30: Remote – System Settings Configuration Screen
1. Assigning
a
system
Name
– The Name field in the Remote is used for identification
purposes only and appears next to the software revision (see above). This makes it
easier for an administrator when managing multiple sites. Typically the geographic
location of the unit is input “New York Office” for example. Any text up to 15
characters can be input in this field.
2. Configuring
to
Use Gateway Time
– The log files for the Remote can be stamped
using the locally configured time (see
Advanced System Utilities – Time and Date
for
time and date configuration) or by using the PBXgateway time. Using the
PBXgateway time is recommended so that time events recorded are consistent at
both the corporate facility and the remote site. This feature will assist during trouble
shooting should the need arise.
3. Setting
the
Gateway Time Offset
– Enter a value that represents the time difference
between the PBXgateway and the Remote. This is used to compensate for the time
difference between cities. For example, if the PBXgateway is at a corporate office in
Seattle and the Remote is at a branch office in New York set this value to +3. This
ensures that the log time stamp and the telephone display use the correct time.
4. Changing
the
Console baud
– This is the speed at which information is transmitted to
and from the PBXgateway through the console port labeled “COMM” on the back of
the unit. The baud rate can be changed to 2400, 4800, 9600, 19200 or 38400. The
default is 9600.
5. Enabling
for
IP Office
(
Definity and Magix only
) – If telephone sets normally used for
Avaya IP Office are used on the system when it is configured for the Definity or Magix
PBX type then the IP Office parameter must be set to ‘Yes’. Refer to
Table 15:
Supported Telephones – Definity, Magix and IP Office
for more information.
The IP Office field will only be presented when the Remote is configured for the Definity or
Magix PBX types.
Document Number: M-4100-MUC
Version: Rev AA
© Copyright 2007 Citel plc All Rights Reserved
