Cisco ONS 15454, Руководство по установке оборудования

Страница: 175 / 516

Completed Description
NTP-G13 Install the Rear Cover (ANSI Only), on page 118
NTP-G14 Install DWDM Equipment, on page 123
NTP-G15 Install the Common Control Cards, on page 131
NTP-G301 Connect the ONS 15454 Multishelf Node and Subtending Shelves to an MS-ISC-100T
Card, on page 138
or NTP-G295 Connect the ONS 15454 Multishelf Node and Subtending
Shelves to a Catalyst 2950 or Catalyst 3560, on page 146
NTP-G298 Configure a Cisco Catalyst 2950 or Catalyst 3560 (Active and Standby) for a ONS
15454 Multishelf Node, on page 152
(if you completed NTP-G295 Connect the ONS 15454
Multishelf Node and Subtending Shelves to a Catalyst 2950 or Catalyst 3560, on page 146 )
Step 3 Complete the DLP-G35 Inspect the Shelf Installation and Connections , on page 145 .
Step 4 Complete the DLP-G36 Measure Voltage , on page 146 .
Step 5
Continue with “ Connect the PC and Log into the GUI ” document.
Stop. You have completed this procedure.
DLP-G35 Inspect the Shelf Installation and Connections
Use this task to inspect the shelf installation and connections and verify that
everything is installed and connected properly. Purpose
None
Tools/Equipment
None Prerequisite
Procedures
Required Required/As Needed
Onsite Onsite/Remote
None Security Level
Procedure
Step 1 Make sure all external wiring connections on the backplane (that is, power, ground, alarms, etc.) are secure.
If a wire or cable is loose, return to the appropriate procedure in this chapter to correct it.
Step 2
(ETSI only) To check that the FMEC cover is seated correctly, verify that it can be easily closed without
disturbing cables.
Step 3
Return to your originating procedure (NTP).
Cisco ONS 15454 Hardware Installation Guide
145
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G35 Inspect the Shelf Installation and Connections