Cisco ONS 15454, Руководство по установке оборудования

Страница: 96 / 516

NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only)
This procedure installs the MIC-A/P and the MIC-T/C/P FMECs in the EFCA.
The EFCA is located at the top of the ONS 15454 ETSI shelf. It provides
connection for installing power, external alarms, timing input and output, and
craft interface terminals. Purpose
#2 Phillips Dynamometric screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
FMECs (the MIC-A/P and MIC-T/C/P)
Tools/Equipment
NTP-G4 Open and Remove the FMEC Cover (ETSI Only), on page 60 Prerequisite Procedures
Required
Required/As Needed
Onsite Onsite/Remote
None Security Level
Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock,
keep hands and fingers out of the power supply bays and backplane areas.
Statement 166
Warning
Always use the supplied ESD wristband when working with a powered ONS 15454 ETSI. For detailed
instructions on how to wear the ESD wristband, refer to the
Electrostatic Discharge and Grounding Guide for
Cisco CPT and Cisco ONS Platforms .
Caution
The ONS 15454 ETSI EFCA has 12 FMEC slots numbered sequentially from left to right beginning with Slot
18. Slots 18 to 22 and 25 to 29 provide electrical connections for the corresponding slots, so they are
unnecessary in DWDM applications.
Note
Procedure
Step 1 Ensure that you are installing the FMECs in the correct slot:
• FMEC Slot 23 supports the MIC-A/P.
The MIC-A/P card provides connection for the BATTERY B input, one of the two possible redundant power
supply inputs. It also provides connection for eight alarm outputs (coming from the TCC2/TCC2P/TCC3
card), sixteen alarm inputs, and four configurable alarm inputs/outputs.
• FMEC Slot 24 supports the MIC-C/T/P.
Cisco ONS 15454 Hardware Installation Guide
66
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only)