Cisco Cisco ONS 15600 SDH, Руководство по устранению неисправностей

Страница: 285 / 318

4-29
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-3327 An error occurred while retrieving thresholds. There was an error retrieving the thresholds.
This message is displayed only for the
OSCM/OSC-CSM line thresholds.
EID-3328 An error occurred while applying changes to row {0}.
The value is out of range.
There was an error applying the changes to
the specified row. The value is out of range.
EID-3330 Unable to switch to the byte because an overhead channel is
present on this byte of the port. Refer to the error message text.
EID-3331 An error occurred while applying changes to the row. Refer to the error message text.
EID-3334 Timing parameters on the protect port cannot be changed. You cannot change timing parameters on
protect port.
EID-3335 The port type cannot be changed because the SDH validation
check failed. Check if this port is part of a circuit, protection
group, SONET DCC, orderwire, or UNI-C interface. Refer to the error message text.
EID-3336 An error occurred while reading a control mode value. The Control Mode must be retrieved.
EID-3337 An error occurred while setting a set point gain value. The Gain Set Point must be set.
EID-3338 An error occurred while reading a set-point gain value. The Gain Set Point must be retrieved.
EID-3339 An error occurred while setting a tilt calibration value. The tilt calibration must be set.
EID-3340 An error occurred while setting expected wavelength. The expected wavelength must be set.
EID-3341 An error occurred while reading expected wavelength. The expected wavelength must be retrieved.
EID-3342 An error occurred while reading actual wavelength. The actual wavelength must be retrieved.
EID-3343 An error occurred while reading actual band. The actual band must be retrieved.
EID-3344 An error occurred while reading expected band. The expected band must be retrieved.
EID-3345 An error occurred while setting expected band. The expected band must be set.
EID-3346 An error occurred while retrieving defaults from the node: {0}. There was an error retrieving defaults from
the specified node.
EID-3347 The file {0} cannot be loaded. CTC cannot load the specified file.
EID-3348 Properties cannot be loaded from the node. Refer to the error message text.
EID-3349 NE update properties cannot be saved to a file. Check your file system for space constraint
or any other problem.
EID-3350 NE update properties cannot be loaded from the node. Refer to the error message text.
EID-3351 The file {0} does not exist. The specified file does not exist.
EID-3352 An error occurred while setting a value at {0}. There was an error while setting the value at
the specified location.
EID-3353 No such interface is available. The interface specified is not present in
CTC.
EID-3354 The specified endpoint is in use. Select another endpoint that is not in use.
EID-3355 The specified endpoint is incompatible. Refer to the error message text.
EID-3357 The connections could not be calculated. Refer to the error message text.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description