Cisco Cisco ONS 15600 SDH, Руководство по устранению неисправностей

Страница: 296 / 318

4-40
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
July 2010
Chapter 4 Error Messages
EID-6029 The next hop of a static route cannot be the same as the
destination of the route or an internal network{0}. Static route must have the default route as
the next hop, and not destination of the
route or internal network.
EID-6030 The next hop of a static default route must be the provisioned
default router. The default route is selected for networks
that do not have a specific route.
EID-6031 No more static routes can be created. You have reached the maximum number of
static routes.
EID-6032 This static route already exists. Refer to the error message text.
EID-6033 A previous operation is still in progress. Another operation is in progress. You must
try after sometime.
EID-6035 The parent entity does not exist. Refer to the error message text.
EID-6036 The parent PPM entity does not exist. Create a parent entity for the PPM.
EID-6037 This equipment type is not supported. CTC does not support this equipment.
EID-6038 The PPM port is invalid. Refer to the error message text.
EID-6039 The card is part of a regeneration group. Select another card.
EID-6040 Out of memory. Refer to the error message text.
EID-6041 The port is already present. Refer to the error message text.
EID-6042 The port is used as timing source. Choose another port because the selected
port is being used as a timing source.
EID-6043 A DCC or GCC is present. Refer to the error message text.
EID-6044 The card or port is part of protection group. Refer to the error message text.
EID-6045 The port has overhead circuit(s). Refer to the error message text.
EID-6046 The ITU-T G.709 configuration is not compatible with the data
rate. Refer to the error message text.
EID-6047 The port cannot be deleted because its service state is
OOS-MA,LPBK&MT. To delete the port, you must change the port
state to Locked,disabled.
EID-6048 {0} is {1}. The trunk port is in the wrong state to carry
out the action.
EID-6049 The card operating mode of {0} is not supported. CTC does not support the mode of
operation requested on the card.
EID-6050 Some {0} terminations were not {1}d.
{2}
Refer to the error message text.
WID-6051 All {0} terminations were {1}d successfully.
{2}
Refer to the warning message text.
EID-6052 The authentication key can not be blank. Enter an authentication key.
EID-6053 No more SNMP trap destinations can be created. You have reached the maximum number of
SNMP trap destinations.
EID-6054 {0} is not a valid IP address for an SNMP trap destination. The IP address specified is not a valid
receiver of SNMP traps.
Table 4-1 Error Messages (continued)
Error Warning
ID
Error Warning Message Description