Cisco Catalyst 3750-E Series, Руководство по настройке программного обеспечения

Страница: 384 / 1414

12-14
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 12 Configuring Interface Characteristics
Using Interface Configuration Mode
Step 2
Enter the interface global configuration command. Identify the interface type, the switch number (only
on Catalyst 3750-E switches), and the number of the connector. In this example, Gigabit Ethernet port 1
on switch 1 is selected:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)#
Note
You do not need to add a space between the interface type and the interface number. For example,
in the preceding line, you can specify either
gigabitethernet 1/0/1 , gigabitethernet1/0/1 ,
gi 1/0/1 , or gi1/0/1 .
Step 3
Follow each interface command with the interface configuration commands that the interface requires.
The commands that you enter define the protocols and applications that will run on the interface. The
commands are collected and applied to the interface when you enter another interface command or enter
end to return to privileged EXEC mode.
You can also configure a range of interfaces by using the interface range or interface range macro
global configuration commands. Interfaces configured in a range must be the same type and must be
configured with the same feature options.
Step 4
After you configure an interface, verify its status by using the show privileged EXEC commands listed
in the “Monitoring and Maintaining the Interfaces” section on page 12-39 .
Enter the show interfaces privileged EXEC command to see a list of all interfaces on or configured for
the switch. A report is provided for each interface that the device supports or for the specified interface.
Configuring a Range of Interfaces
You can use the interface range global configuration command to configure multiple interfaces with the
same configuration parameters. When you enter the interface-range configuration mode, all command
parameters that you enter are attributed to all interfaces within that range until you exit this mode.
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same parameters:
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 interface range { port-range | macro
macro_name }
Specify the range of interfaces (VLANs or physical ports) to be
configured, and enter interface-range configuration mode.
• You can use the interface range command to configure up to five
port ranges or a previously defined macro.
•
The macro variable is explained in the “Configuring and Using
Interface Range Macros” section on page 12-16 .
• In a comma-separated port-range , you must enter the interface
type for each entry and enter spaces before and after the comma.
•
In a hyphen-separated port-range , you do not need to re-enter the
interface type, but you must enter a space before the hyphen.