Cisco Catalyst 3750-E Series, Руководство по настройке программного обеспечения

Страница: 339 / 1414

10-55
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
Configuring 802.1x Authentication
Step 4 radius-server host ip-address
[acct-port udp-port ] [ auth-port
udp-port ][ test username name
[ idle-time time ]
[ ignore-acct-port ]
[ ignore-auth-port ]] [ key
string ]
(Optional) Configure the RADIUS server parameters by using these keywords:
•
acct-port udp-port— Specify the UDP port for the RADIUS accounting
server. The range for the UDP port number is from 0 to 65536. The default is
1646.
•
auth-port udp-port— Specify the UDP port for the RADIUS authentication
server. The range for the UDP port number is from 0 to 65536. The default is
1645.
Note
You should configure the UDP port for the RADIUS accounting server
and the UDP port for the RADIUS authentication server to nondefault
values.
•
test username name —Enable automated testing of the RADIUS server
status, and specify the username to be used.
• idle-time time— Set the interval of time in minutes after which the switch
sends test packets to the server. The range is from 1 to 35791 minutes. The
default is 60 minutes (1 hour).
•
ignore-acct-port — Disable testing on the RADIUS-server accounting port.
•
ignore-auth-port — Disable testing on the RADIUS-server authentication
port.
•
For key string , specify the authentication and encryption key used between
the switch and the RADIUS daemon running on the RADIUS server. The key
is a text string that must match the encryption key used on the RADIUS
server.
Note
Always configure the key as the last item in the radius-server host
command syntax because leading spaces are ignored, but spaces within
and at the end of the key are used. If you use spaces in the key, do not
enclose the key in quotation marks unless the quotation marks are part of
the key. This key must match the encryption used on the RADIUS
daemon.
You can also configure the authentication and encryption key by using the
radius-server key { 0 string | 7 string | string } global configuration
command.
Step 5
dot1x critical { eapol | recovery
delay milliseconds }
(Optional) Configure the parameters for inaccessible authentication bypass:
eapol —Specify that the switch sends an EAPOL-Success message when the
switch successfully authenticates the critical port.
recovery delay milliseconds —Set the recovery delay period during which the
switch waits to re-initialize a critical port when a RADIUS server that was
unavailable becomes available. The range is from 1 to 10000 milliseconds. The
default is 1000 milliseconds (a port can be re-initialized every second).
Step 6 interface interface-id Specify the port to be configured, and enter interface configuration mode. For the
supported port types, see the
“802.1x Authentication Configuration Guidelines”
section on page 10-35 .
Command Purpose