45-7
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Chapter 45 Configuring Cache Services By Using WCCP
Configuring WCCP
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip wccp
{
web-cache
|
service-number
}
[
group-address
groupaddress
]
[
group-list
access-list
] [
redirect-list
access-list
] [
password
encryption-number password
]
Enable the cache service, and specify the service number which
corresponds to a dynamic service that is defined by the application
engine. By default, this feature is disabled.
(Optional) For
group-address
groupaddress
, specify the multicast group
address used by the switches and the application engines to participate in
the service group.
(Optional) For
group-list
access-list
, if a multicast group address is not
used, specify a list of valid IP addresses that correspond to the application
engines that are participating in the service group.
(Optional) For
redirect-list
access-list
, specify the redirect service for
specific hosts or specific packets from hosts.
(Optional) For
password
encryption-number password
, specify an
encryption number. The range is 0 to 7. Use 0 for not encrypted, and use
7 for proprietary. Specify a password name up to seven characters in
length. The switch combines the password with the MD5 authentication
value to create security for the connection between the switch and the
application engine. By default, no password is configured, and no
authentication is performed.
You must configure the same password on each application engine.
When authentication is enabled, the switch discards messages that are not
authenticated.
Step 3
interface
interface-id
Specify the interface connected to the application engine or the server,
and enter interface configuration mode.
Step 4
no switchport
Enter Layer 3 mode.
Step 5
ip address
ip-address subnet-mask
Configure the IP address and subnet mask.
Step 6
no shutdown
Enable the interface.
Step 7
exit
Return to global configuration mode. Repeat Steps 3 through 7 for each
application engine and server.
Step 8
interface
interface-id
Specify the interface connected to the client, and enter interface
configuration mode.
Step 9
no switchport
Enter Layer 3 mode.
Step 10
ip address
ip-address subnet-mask
Configure the IP address and subnet mask.
Step 11
no shutdown
Enable the interface.
Step 12
ip wccp
{
web-cache
|
service-number
}
redirect in
Redirect packets received from the client to the application engine.
Enable this on the interface connected to the client.
Step 13
ip wccp
{
web-cache
|
service-number
}
group-listen
(Optional) When using a multicast group address,
group-listen
enables
the interface to listen for the multicast address. Enable this on the
interface connected to the application engine.
Step 14
exit
Return to global configuration mode. Repeat Steps 8 through 13 for each
client.
Step 15
end
Return to privileged EXEC mode.
Содержание Catalyst 3750-E Series
Страница 48: ...Contents xlviii Catalyst 3750 E and 3560 E Switch Software Configuration Guide OL 9775 08 ...
Страница 52: ...lii Catalyst 3750 E and 3560 E Switch Software Configuration Guide OL 9775 08 Preface ...
Страница 1414: ...Index IN 58 Catalyst 3750 E and 3560 E Switch Software Configuration Guide OL 9775 08 ...
