Chevrolet 10 Series 1968, Руководство по обслуживанию

Страница: 124 / 713

BODY IB-57
in
........
—.....
RUN CHANNEL
RETAINER
GLASS RUN
CHANNEL
F ig . 125 - Engagement of G la ss Run Channel
4. Disengage lug of glass run channel from slot of run
channel retainer as shown in Figure 125. Remove
retainer (18).
5. Roll window to bottom, then referring to Figure 126,
detach regulator arm from window glass lower chan­
nel by removing retainer clip which retains arm pin
in channel slot. Disengage arm pin from channel,
then lower glass assembly out door lower opening
(fig. 127).
6. Soak glass fille r along glass channel to soften filler.
Remove glass from channel when fille r is sufficiently
soft.
Installation
NOTE:
124.
Key numbers in text refer to Figure
1. Thoroughly clean inside of glass channel, removing
all rust and foreign matter.
2. Cut new piece of fille r to length of glass regulator
channel.
3. Brush inside of glass regulator channel freely with
light engine oil.
4. Position fille r (soapstone side away from glass)
around edge of glass, centered between corners of
glass.
IM PORTANT: Before installing new glass in
regulator channel, make sure that the outer edge
of glass having rounder corner is located so that
smooth side of channel is located as shown in
Figure 128.
5. When installed, bottom of glass must be centered in
glass regulator channel (fig. 128). Press glass with
fille r into channel until firm ly seated.
6. Position glass assembly into opening at bottom of
door (fig. 127) and engage edges of glass in door
front and rear glass run channels.
7. Engage regulator arm pin in glass channel with
leather washer located each side of channel as shown
in Figure 129. Install pin fastener.
8. Raise window, then referring to Figure 125, engage
lug of sash run channel into slot of run channel re­
tainer. Install two screws into holes (fig. 125) at­
taching retainer to door edge framing.
9. Raise and lower door window to check for binding. If
binding exists, division channel attaching screws (9
and 21) should be loosened to allow channel to shift
for free operation of window. Retighten screws after
making adjustment.
10. Install access panel (8), to opening at bottom of door.
DOOR VENT GLASS
NOTE: This procedure covers replacement of
the vent glass only.
Removal
1. Remove small access panel from inner side of door
below vent window. Figure 130 shows access panel
removed.
F ig . 1 2 6 - Replacing Regulator Arm Retainer
REGULATOR ARM
POINTED TOOL
IN STA LLIN G RETAINER
CHEVROLET TRUCK SERVICE MANUAL