Caton CatonCaster HD422, Руководство пользователя

Страница: 92 / 107

CatonCaster HD422 User Manual
Page of 92 107 www.catontechnology.com July 2020 R1
Error Description
Auto Video Format
Error CatonCaster HD422 is unable to determine the native incoming video in order to
format output.
BISS Conflicting PIDs PIDs selected to be descrambled by one BISS key are already assigned to be
descrambled by another BISS key.
BISS Service Not
Found Service that BISS key is assigned to descramble is not present in the incoming
stream.
Backup Input Active
Condition Primary input is currently in a failed condition and the CatonCaster HD422 has
failed over to the Backup input.
Bitrate Exceeded Error Total incoming transport stream bitrate has exceeded 213 Mbps.
CAM Descramble Fail
CAM Not Present CAM Module is not descrambling selected PIDs or services
DVB-CI Descrambling is enabled but CAM Module is not installed.
CAM PID Not Found PID selected to be descrambled by the CAM is not present in the incoming
stream.
ES Type Mismatch Elementary stream type does not match the stream type defined by the user.
FEC Reception Error Packets in incoming IP stream cannot be repaired with forward error correction.
Fan Speed Below
Lower Limit Cooling fan in the CatonCaster HD422 has failed.
Genlock Not Present Genlock reference is enabled but not present.
IP Loss Error No IP packets have been received by the MPEG/IP card for two seconds.
ISI Not Found ISI value defined by the user is not found in the incoming multistream signal.
Incompatible Genlock
Reference External genlock reference is not compatible with output video format.
Input Video
Unsupported Native format of incoming video is not a supported video format.
LNB Power Error LNB Power is enabled but the CatonCaster HD422 is detecting power is being
provided by another source, there is excessive current drain or an overvoltage
has occurred.
Link Loss Error Physical IP link is not present on the MPEG/IP card.
Loss of Carrier Lock Receiver carrier lock source is lost.
Low Level 8VSB/QAM RF Level is below the user settable threshold
Low Mer 8VSB/QAM MER is below the user settable threshold
Multistream Mode Input
Mismatch Multistream Mode is enabled and input signal is not multistream capable or
Multistream Mode is disabled and input signal is multistream capable.
No Services Detected Service Lock service selection mode is enabled but no services are present in
the active input transport stream.
PID Filter Overflow
Error Configured PID Filter TS rate is too low.