CatonCaster HD422 User Manual
4.2.29 Configuring the MPEG/IP MPE Outputs
This menu allows the user to configure the MPEG/IP Multi-Protocol Encapsulation (MPE) outputs. Each MPE
Output allows the user to select an MPE data PID from the transport stream to be output.
Page of
68
107
www.catontechnology.com
July 2020 R1
Setting
Range
Description
Destination Port 0 - 65535
When sending to a unicast address, the destination port
must match the receiving device’s port. When sending a
multicast, any port within the accepted range can be
used, but it is good practice to always choose a port
>1030 and an even number
Source Port
0 - 65536
This is the port used by the CatonCaster HD422 to
transmit the MPEG/IP stream.
TS Packets Per
IP Packet
1-7
The number of TS packets that are contained with a
single IP packet. Default is 7. Lowering this value below
default increases network overhead.
Differentiated
Services
Default
Assured Forwarding 1-1 to
4-3
Expedited Forwarding
Define the quality of service (QoS) classification the
packets carry when transmitted.
Encapsulation
UDP
RTP
Sets the Encapsulation to UDP or RTP.
FEC
Off
Columns
Columns/Rows
Sets the FEC Type or disables FEC.
FEC Columns
1-20 (Columns)
4-20 (Columns/Rows)
Defines the number of Columns used to construct the
FEC Matrix. (Columns * Rows must be
≤
100.)
FEC Rows
4-20
Defines the number of Rows used to construct the FEC
Matrix. (Columns * Rows must be
≤
100.)
