CatonCaster HD422 User Manual
4.2.2 Configuring ASI Input
This menu allows the user to either Enable or Disable the ASI Input on the CatonCaster HD422. Beginning
with revision J main boards the ASI ports can be configured as either an input or output. Earlier revision
remain configured as 1 input and 1 output port. Main board version can be located on the “About” tab under
the Options section.
Rev I and earlier main board ASI options
Rev J and later main board ASI options
4.2.3
Configuring MPEG/IP Input
If the MPEG/IP Input card was selected as a factory installed option, the following menus and options will be
available for configuration. This menu allows the user to configure the MPEG/IP inputs. Each MPEG/IP card
has two ports that can be set to receive and/or transmit. This menu is for setting up the reception of MPEG/
IP unicast or multicast transport streams. The menu for Stream 1 and 2 have the same settings. IGMPv2 is
used to join/leave multicast streams by default if no IGMP Filter addresses are entered. If IGMP Filter Mode
addresses are specified then IGMPv3 is used.
Page of
25
107
www.catontechnology.com
July 2020 R1
Setting
Range
Description
Direction
Input
Output
Configure the ASI port to either an input or an output.
Applies only to main board revision J or later. Main
board version can be located on the about tab under the
Options section.
Port
Enabled
Disabled
This setting allows the user to enable or disable the ASI
Input to the CatonCaster
Null Stripped
Enabled
Disabled
Enabling Null Stripped allows the CatonCaster HD422 to
receive streams that do not contain null packets (i.e.
VBR Transport Streams)
