CatonCaster HD422 User Manual
IP statistics menu
4.2.4
Configuring DVB-S/S2/S2X Input
If the DVB-S/S2/S2X Input card was selected as a factory installed option, the following menus and options
will be available for configuration. This menu allows the user to configure the DVB-S/S2/S2X inputs. The
input card is equipped with dual demodulators and four ports (labeled A, B, C and D). This configuration
allows the card to receive two signals simultaneously for fast switching between primary and backup inputs.
The menu for both demodulators have the same settings. The input card will automatically detect modulation
and symbol rate during signal acquisition. LNB Power configuration for this input card is done in the Admin
tab.
Page of
28
107
www.catontechnology.com
July 2020 R1
Receive
Enabled
Disabled
This setting allows the user to enable or disable this
input stream.
Physical
Connector
Port A
Port B
Port C
Port D
This setting allows the user to select which physical RF
connector will be used to receive the stream.
Satellite
Frequency
C-Band: 4GHz – 8GHz
Ku Band: 11.2Ghz – 14.5Ghz
L-Band: 950MHz – 2150MHz
Dependent on LO Offset
If LO Offset is set to 0 then L-Band frequency is entered
into the Satellite Frequency dialog box. If LO Offset to
set to a pre-defined option then enter C-band or Ku-Band
frequency.
LO O
ff
set
5150
9750
10600
10750
11250
The offset in MHz that the local oscillator is operating.
PL Scrambling
Code
0 – 262141
The CatonCaster has the ability to receive satellite
signals scrambled using PL Scrambling. In order to
receive the stream, enter the value of the incoming
signals PL Scrambling code.
