Canon P 400, Руководство по обслуживанию

Страница: 11 / 88

WARNING:
Make sure you shut down the imagePRESS Server before opening the imagePRESS Server to service the inside parts.
Mise en garde:
Veillez à éteindre imagePRESS Server avant de l'ouvrir en vue d'effectuer l'entretien des éléments internes.
Attenzione:
Accertarsi di spegnere il imagePRESS Server prima di aprirlo per eseguire la manutenzione delle parti interne.
Achtung:
Stellen Sie sicher, dass Sie den imagePRESS Server vor dem Öffnen herunterfahren, wenn Sie die Innenteile des
imagePRESS Server warten möchten.
Precaución:
Asegúrese de apagar el imagePRESS Server antes de abrirlo para realizar labores de mantenimiento en las piezas
internas.
Cuidado:
Desligue o imagePRESS Server antes de abri-lo para fazer a manutenção das peças internas.
Opgelet:
Zorg ervoor dat u de imagePRESS Server uitschakelt voordat u de imagePRESS Server opent voor onderhoud van
de interne onderdelen.
Forsigtighed:
Sørg for at slukke for imagePRESS Server, før du åbner imagePRESS Server for at servicere de indvendige dele.
Forsiktighet:
Sørg for at du slår av imagePRESS Server før du åpner imagePRESS Server for å vedlikeholde de innvendige delene.
Huomautus:
Varmista, että sammutat imagePRESS Server ennen imagePRESS Server avaamista sisäosien huoltoa varten.
Försiktighet:
Se till att du stänger av imagePRESS Server innan du öppnar den för att utföra underhåll på de inre komponenterna.
Electrostatic discharge
When you work with electronic components, electrostatic discharge is a concern since it can destroy circuits, or damage them,
reducing their life span. The area around the printer is most likely not static-free, and electrostatic discharge could occur.
To avoid damage due to electrostatic discharge, do the following:
• Work on a grounded antistatic mat.
• Wear an antistatic wristband, attached to the same location as the antistatic mat.
• Before you remove an electronic component from the shipping box, touch a metal area of the printer to discharge static from
your body.
• After you remove an electronic component from the shipping box, place it face up on a grounded antistatic surface.
• Leave electronic components in antistatic bags until you are ready to use them.
• Do not walk on carpet or vinyl while carrying an electronic component, unless it is in an antistatic bag.
• If you remove an electronic component from the printer, immediately place it in an antistatic bag.
Power cable
Observe the following guidelines:
• Only use the power cable that shipped with the imagePRESS Server or an appropriate replacement power cable.
For replacement parts, see your authorized service support center.
• Before you open the imagePRESS Server , unplug the imagePRESS Server .
• Keep the power cable away from foot traffic.
• Do not place objects on the power cable.
• Do not plug the
imagePRESS Server into a 2-hole, ungrounded power outlet by means of a 3-prong adapter.
• Do not plug the imagePRESS Server into a circuit connected to heating or refrigeration equipment (including a water
dispenser).
• Do not plug the imagePRESS Server into a switchable power outlet.
• Do not pull the cable to unplug the imagePRESS Server . Instead, pull the plug.
• Do not tamper with or disable the power cable grounding plug.
• Do not use an extension cord.
1. Introduction
5