Canon iR5570 Series, Руководство по обслуживанию

Страница: 553 / 684

Chapter 15
15-13
15.2.2 E602 in Detail
0009-7924
<E602-XXYY>
- XX= '00'
T-15-3
- XX= '01 to FF'
T-15-4
XX YY Description Remedy
00
01
The HDD is not recognized.
At start-up, the start-up partition
(BOOTDEV) is not found. 1. Turn off the power, and check the HDD cable for
disconnection; then, turn the
power back on.
2. Turn on the power, and put your ear or finger against the
HDD to see if the disk inside it is rotating.
3. Replace the HDD.
4. Replace the main controller PCB.
02
The system software for the
main CPU is absent. 1. Start up in safe mode, and execute full formatting using the
SST; then, re-install
the system software, and turn off and then on the power.
2. Replace the HDD.
03
An interrupt has been detected
during writing to BootDevice. 1. Turn off the power, and turn it back on while holding down
the 1 and 9 keys.
See that the auto write interrupt sector repair routine starts and
the control panel goes
black.
2. See the progress of operation on the display (at the start, the
upper left cursor
will flash). When the display goes white, turn off and then back
on the power.
3. Start in safe mode, and execute full formatting using the SST.
Then, re-install
the system software, and turn off and then back on the power.
XX YY
XX
CHK-
TYPE
Partition Description
At start-up During operation
1 2 3
11,2
1
13,2
5
10,12,14,22,
23,24
Remedy Remedy
01
1
FSTDEV
compressed image data
(e.g., Box)
*1 *5
*9 *10 *11 *12
02 IMG_MNG
file management table,
profile
03 FSTCDEV job archiving (chasing)
04
2
APL_GEN general data
05 TMP_GEN
general data (temporary
file)
06 TMP_FAX for fax (temporary file)
07 TMP_PSS
for PDL spool (temporary
file)
08 3 PDLDEV for PDL spool (e.g., font)
09 4 BOOTDEV
firmware (system, MEAP,
key, certificate, PDF
dictionary, RUI content,
audio
dictionary)
*3 *8
10 5 APL_MEAP MEAP application *1 *5
11 6 APL_SEND address book, filter *2 *6
FF 0
Not
identified
full check on HDD for
faulty sector and recovery
*4 *7