Canon iR5570 Series, Руководство по обслуживанию

Страница: 498 / 684

Chapter 13
13-26
F-13-50
After mounting the cleaning blade, check to make sure that the edge of
the blade is not appreciably bent.
Further, be sure to clean the groove in the blade support plate before
mounting the blade, as toner or the like in the groove can start to bend
the blade.
13.5.6 Mounting the Side Seal
0009-5705
1) Mount the side seal [1] to the cleaner housing where indicated (both
ends). AT this time, be sure that the edge of the side seal is positioned
as follows:
- When replacing the side seal [1] at the front, push the magnet roller [2]
toward the rear and then make sure that the inner end of the side seal
is within the area [3] of the washer.
- When replacing the side seal [1] at the rear, push the magnet roller [2]
toward the front and then make sure that the inner end of the side seal
is within the area [3] of the washer.
2) The bottom end of each side seal [1] must be 0 to 0.5 mm from the
corner of the cleaner hosing; i.e., point of reference [4].
3) Attach the side seal [1] at the front and the rear to the cleaner housing
while making sure its position is as indicated.
F-13-51
order of tightening
5
[3]
3 1 2 4
0 0.5mm
[3]
[2]
[1]
[4]
[1]