Canon ImageRunner iR8500 Series, Руководство по обслуживанию, Страница: 393 / 1122

Chapter 8
8-53
8.9.15 Separation Claw/Separation Claw Drive
Assembly
8.9.15.1 Separation Claw/Separation Claw Drive
Assembly
0007-2395
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Open the front cover.
2) Take out the process unit.
3) Remove the E-ring [1], and slide out the separation claw holder shaft
[2] to the front to detach the separation holder [3].
F-8-124
4) Remove the spring [4], and detach the separation claw [5].
F-8-125
Points to Note When Mounting
When mounting the separation claw holder, be sure that the separation
claw holder spring is butted against the drum cleaner case. Further,
check to make sure that the rack of the separation claw 3 drive assembly
is engaged with the groove in the separation claw holder.
F-8-126
8.9.16 Potential Sensor
8.9.16.1 Removing the Potential Sensor Unit
0007-2052
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Open the front cover.
2) Remove the process unit.
3) Push in the fixing/feeding assembly.
4) Disconnect the two connectors [1], and pull out the dust-proofing
glass [2]; then, remove the screw [3], and detach the potential sensor
unit [4].
F-8-127
It is difficult to pull out the potential sensor in a horizontal direction. As
shown, shift it down once, and then slide it out to facilitate the work.
F-8-128
5) Remove the two screws [5], and detach the potential sensor cover [6];
then, detach the potential sensor [7].
F-8-129
[2]
[3]
[1]
[5]
[4]
Separation claw holder
Rack
[1]
[1]
[2]
[3]
[4]
[5]
[6]
[7]