Canon imageRUNNER ADVANCE C255 Series, Руководство по обслуживанию, Страница: 844 / 987

■ P-STOP
COPIER (Service mode for copier) > TEST (Print test mode) > P-STOP
PRINTER 1 Forcible stop of paper feed
Detail To forcibly stop paper for the next job at the specified position (only once).
Leading edge of paper stops at the specified position so that the cause of a problem can be
identified.
Set 99 when checking an image on the ITB.
When the operation is stopped forcibly, jam code "AAxx" is displayed.
When a normal jam occurs at a position other than the specified position or paper is delivered
without being forcibly stopped, this setting is automatically cleared.
Use Case - When bent paper/skew/wrinkles occur
- When jam occurs frequently
- When checking an image on the ITB
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Execute a job (copy/test print).
Paper stops at the specified position.
Caution - Remove the paper being stopped with the normal jam removal procedure. After jam removal, the
job is automatically recovered.
- Because the Primary Transfer Roller is not disengaged when a jam occurs, manually disengage
the roller (refer to the Service Manual for the procedures) and then remove the ITB Unit/Drum Unit.
- Display of standard jam code indicates that a jam occurs somewhere other than the specified
position. Setting of forcible stop is enabled until paper stops at the specified position.
- The setting is disabled for job where paper does not pass through the specified position.
- Unfixed toner may be adhered on paper depending on the stop position. Thus, handle it with
care.
Display/Adj/Set Range 0 to 255
0: Not forcibly stopped
1: After pickup from the Cassette 1
2: After pickup from the Cassette 2
3: After pickup from the Cassette 3
4: After pickup from the Cassette 4
20: Pre-registration (1st side)
21: Pre-registration (2nd side) *1
30: Secondary Pre-transfer (1st side)
31: Secondary Pre-transfer (2nd side) *1
32: Pre-fixing
40: Post-fixing
70: Post-reverse *1
71: Duplex standby position *1
99: Secondary Pre-transfer (when checking the image)
Any values other than those mentioned above: Not used
*1: Paper is stopped when a duplex job is executed (paper is stopped after being reversed)
Default Value 0
COUNTER (Counter mode)
■ TOTAL
COPIER (Service mode for copier) > COUNTER (Counter mode) > TOTAL
SERVICE1 1 Service-purposed total counter 1
Detail To count up when the paper is delivered outside the machine.
Large size: 1, small size: 1
A blank sheet is not counted.
Display/Adj/Set Range 0 to 99999999
8. Service Mode
833