Canon imageRUNNER ADVANCE C255 Series, Руководство по обслуживанию, Страница: 725 / 987

COPIER (Service mode for copier) > OPTION (Specification setting mode) > FNC-SW
CARD-RNG 2 Card number setting (department number)
Detail To set the number of cards (departments) that can be used with the Card Reader.
Use Case When setting the number of cards (departments)
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 1 to 1000
Default Value 1000
SJOB-CL 1 Set of scan job canceling by logout
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to cancel the scan job in operation by logout of the user.
Use Case
Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution
The job with scanning completed cannot be canceled.
Display/Adj/Set Range
0 to 2
0: Cancel only scan job in waiting state, 1: Cancel all scan jobs, 2: Not canceled
Default Value
0
Supplement/Memo Scan job: A job after the scanning operation is completed.
MIBCOUNT 2 Scope range set of Charge Counter MIB
Detail To set the range of counter information that can be obtained as MIB (Management Information
Base).
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 2
0: All charge counters are obtained, 1: Only displayed counter* is obtained, 2: All charge counters
are not obtained
* : Counter specified by the following: COPIER> OPTION> USER> COUNTER 1 to 6
Default Value 0
Related Service Mode COPIER> OPTION> USER> COUNTER1 - 6
CNTR-SW 1 Init parts counter estimated life value
Detail To return the estimated life of parts counter to the initial value.
If either "00000000" or a value before the specification change is displayed in the estimated life
value of the parts counter, set 0 after upgrading of the firmware.
Use Case
- When either "00000000" or a value before the specification change is displayed in the estimated
life value of the parts counter
- When changing the state back to the initial state after entering the estimated life value manually
Adj/Set/Operate Method
1) Enter 0, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0: Returned to the initial value
Default Value
0
8. Service Mode
714