Canon imageRUNNER ADVANCE C255 Series, Руководство по обслуживанию, Страница: 343 / 987

Next time a job occurs, the paper is forcibly stopped at the stop position (leading edge) shown in the figure for troubleshooting.
When checking the image on the ITB, set PRINTER=99. (Refer to "How to Use" shown below.)
When the paper is forcibly stopped, a jam code "AAxx" is displayed.
When the paper is forcibly stopped, when a normal jam occurs or the paper is normally delivered, the PRINTER setting is
automatically cleared.
PS12
PS11
PS01
PS04
PS05
PS14
PS10
Use case
• When bent paper, skew, or wrinkles occur
• When jams occur frequently
• When you want to check the image on the ITB
Caution
• Remove the stopped paper by the normal jam removal procedure. After the paper is removed, the job will be automatically
recovered.
• Since the Primary Transfer Roller is not disengaged when a jam has occurred, be sure to remove the ITB Unit/Drum Unit
after manually disengaging the Primary Transfer Roller (refer to the Service Manual for the procedure).
• If a normal jam cord is displayed, the paper is jammed at a position other than the specified position.
• When a job in which the paper does not pass the specified stop position is executed, the setting to forcibly stop the paper
becomes disabled.
• Unfixed toner may be attached depending on the stop position. Handle it carefully.
How to Use
Use this function from SITUATION mode.
1. Select the following service mode item.
Service mode top screen > SITUATION > Troubleshooting > Forcible Stop of Paper Feed
2. Select the corresponding service mode name, enter the setting value, and then press the [OK] button.
3. The paper will stop at the specified position. Identify the cause of the trouble.
The following service modes can be operated from this SITUATION mode:
• COPIER > TEST > P-STOP > PRINTER
• COPIER > TEST > PG > TYPE
• COPIER > TEST > PG > PG-PICK
• COPIER > TEST > PG > 2-SIDE
• COPIER > TEST > PG > COLOR-Y
6. Troubleshooting
332