Canon imageRUNNER ADVANCE C255 Series, Руководство по обслуживанию, Страница: 131 / 987

Preface
Outline
This chapter describes disassembly and reassembly procedures of the printer.
The service technician is to identify the cause of printer failures according to the "Chapter 6 TROUBLESHOOTING" and to follow
the disassembly procedures of each part to replace the defective parts or the consumable parts.
Note the following precautions when working on the printer.
1. CAUTION: Before disassembling or reassembling the printer, be sure to disconnect its power cord from the electrical outlet
2. During disassembly, reassembly or transportation of the printer, remove the cartridge if required.
When the cartridge is out of the printer, put it in a protective bag even in a short period of time to prevent the adverse effect
of light.
3. Reassembling procedures are followed by the reverse of disassembly unless otherwise specified.
4. Note the length, diameters, and locations of screws as you remove them. When reassembling the printer, be sure to use
them in their original locations.
5. Do not run the printer with any parts removed as a general rule.
6. Ground yourself by touching the metal part of the printer before handling the PCB to reduce the possibility of damage caused
by static electricity.
7. When you replace the part that the rating plate or the product code label is attached, be sure to remove the rating plate or
the product code label and put it to the new part.
Points to Note when Tightening a Screw
For reduction in weight, thin plates are used in some parts of this machine.
In the case of a screw hole with a triangle mark near it as shown in the figure below, strongly tightening the screw may damage
or deform the screw hole.
In the case of a screw hole with a triangle mark, take care not to apply too much force when tightening the screw.
The recommended torque value is shown below as a reference value.
Type of Screws
RS tight W Sams Binding TP
Fastened member Metal Resin Metal Resin Metal Resin Metal Resin
Tightening
torque
(N*m)
M4 Approx. 1.6 Approx. 1.6 Approx. 1.6 Approx. 0.8 Approx. 1.6 Approx. 0.8 Approx. 1.6 Approx. 0.8
M3 Approx. 0.8 Approx. 0.8 Approx. 0.6 Approx. 0.6 Approx. 0.6 Approx. 0.6 Approx. 0.6 Approx. 0.6
* For PCB, refer to the tightening torque value of resin (fastened member).
RS tight
Type of Screws
W Sams Binding TP
4. Parts Replacement and Cleaning
120