Campbell TurfWeather, Инструкция по эксплуатации

Страница: 69 / 81

TurfWeather Weather Station
h. If you received a replacement main electronics board, it was shipped
in a special ESD protective bag. Remove the replacement main
electronics board from this bag and put the board you removed from
your weather station into the same ESD bag.
3. Main Electronics Board Replacement:
a. If your weather station is wireless, the replacement main electronics
will have a spread spectrum radio board attached to it. The main
carrier frequency for the radio board is printed on the white label with
the word MaxStream. It will be either 900 MHz or 2.4 GHz. Verify
that the carrier frequency is the same as that indicated on the spread
spectrum radio you removed before proceeding further. If it is not,
and you are not intentionally changing the radio frequencies in both
the weather station and the RF401 base station (they must be the same
frequency), then contact your local Toro distributor immediately.
b. Orient the main electronics board so that the connector will mate with
the connector on the sensor connector board. Press the two connectors
together until they are firmly seated.
c. If your weather station is wireless, verify that the Velcro board
retaining strap is tightly secured around the radio module.
d. Replace and tighten the four Phillips head screws that attach the main
electronics board to the weather station electronics section.
e. Place the two sections of the weather station main body together,
making sure that none of the wiring bundles will be crushed by the
edges or by the seven housing screws when the two sections are
secured with screws.
f. Reinstall and tighten the seven screws that hold the weather station
main body sections together.
4. System test:
a. Connect the weather station to the Host computer using the short RS-
232 test cable (if a wired system) and turn on the weather station
power switch; or initiate communications if your weather station is
wireless.
b. Verify that the sensors are reporting values.
c. Re-install the weather station on its mast, and reconnect the ground
and power wires.
62