Campbell TurfWeather, Инструкция по эксплуатации

Страница: 68 / 81

TurfWeather Weather Station
1. Preparation:
a. Turn the power switch on the weather station to the “OFF” position.
b. Disconnect the power input cable and ground wire connections from
the weather station, using the 5/16 inch wrench for the ground wire
connection.
c. Remove the weather station from its location by using the ½ inch
wrench to loosen the two U-bolt nuts that secure the weather station to
its mast. NOTE: Do not remove the mast bracket from the weather
station.
d. Bring the weather station to an enclosed location, preferably near the
Host computer, and place it on a flat stable surface with an area of at
least three times the size of the weather station base.
2. Main Electronics Board Removal:
a. Invert the weather station main body and rest it on a support that
eliminates any stress on the wind speed or wind direction sensors,
and/or the rain gauge. A rolled bath towel placed in the center of the
main body, next to the rain gauge will generally suit the purpose.
b. Remove the seven Phillips head screws on the base of the main body
that hold the base section to the electronics enclosure section. Do not
remove the Phillips head screws that connect the mast bracket to the
weather station base. Notice that the three screws along the end with
the wind sensors are shorter than the remaining four screws.
c. Gently separate the electronics enclosure and base sections of the
weather station main body, taking care not to place any stress on the
wires that connect the two sections.
d. Rest the base section next to the electronics section and locate the
main electronics board within the electronics section. It is the largest
green rectangular electronics board in the weather station electronics
section.
e. Locate the screws at the corners of the main electronics board and
touch one finger to one of the screws. NOTE: Touching the screw will
ground any electro-static energy difference between you and the
weather station main electronics board. Do not be concerned, as this
will not shock you or create a spark.
f. Remove the four Phillips head screws that attach the main electronics
board to the weather station electronics section.
g. Note the gray plastic connector on one end of the main electronics
board. This connects the board to the adjacent sensor connector board.
Grasp both the main electronics board and the sensor connector board
near the connector and gently pull them apart at the mating connector.
You may need to use a slight side-to-side motion to separate the
connector.
61