Campbell TurfWeather, Инструкция по эксплуатации

Страница: 53 / 81

TurfWeather Weather Station
c. Carefully connect the white cable connector to the main electronics
board, taking care not to touch the board or any components on
electronics boards inside the weather station.
d. Align the battery pack cable in the cable restraints and again clamp
them around the entire cable bundle. If your weather station uses cable
ties, then use the ties supplied with the new battery pack and capture
the cable as it was before you clipped the original cable tie(s).
e. Place the two sections of the weather station main body together,
making sure that none of the wiring bundles will be crushed by the
edges, or by the seven housing screws when the sections are secured.
f. Reinstall and tighten the seven screws that hold the weather station
main body sections together.
4. System Test:
a. Turn on the weather station power switch.
b. Look into the small window on the bottom of the weather station
marked “Scan – Receive” and confirm that the LED flashes every ten
seconds.
c. Re-install the weather station on its mast, and reconnect the ground
and power wires.
3.12 Temperature/Relative Humidity Sensor Assembly (P/N
14144) Removal and Replacement Procedure
Please read this entire procedure before beginning work.
The removal and replacement of a TurfWeather weather station
temperature/relative humidity (Temp/RH) sensor assembly does not require
training, special tools, or test equipment. However, the main body of the
weather station does need to be opened, and the person replacing this sensor
46