Campbell TurfWeather, Инструкция по эксплуатации

Страница: 57 / 81

TurfWeather Weather Station
g. Use the Phillips screwdriver to remove the two screws holding the
battery pack bracket into the electronics section, and remove the
bracket.
h. Lift the battery pack from the electronics section and rest it next to the
weather station.
i. Locate the two wires that come from solar radiation sensor and follow
them to their end connector on the weather station main electronics
board. Cut, or disconnect any cable retaining ties along the length of
the wires.
j. Locate the screws on the corners of the main electronics board (largest
green electronics board) and touch one finger to one of the screws on
a corner of the board, then carefully disconnect the black solar
radiation cable connector. NOTE: Touching a screw will ground any
electro-static energy difference between you and the main electronics
board. Do not be concerned, as this will not shock you or create a
spark.
k. Remove the solar radiation sensor by gently pulling it off its mounting
post as you feed the wires through the hole in the top of the weather
station module.
3. Solar Radiation Sensor Replacement:
a. Insert the wire cable from the new solar radiation sensor into the
weather station electronics module through the mounting post hole
where the previous solar radiation sensor was located.
b. Again touch a finger to a screw on a corner of the main electronics
board and then carefully reconnect the black solar radiation sensor
connector. NOTE: Touching the screw will ground any electro-static
energy difference between you and the weather station main
electronics board. Do not be concerned, as this will not shock you or
create a spark.
c. Align the solar radiation sensor cable in the cable restraints and again
clamp them around the cable bundle. If your weather station uses
cable ties, then use the ties supplied with the new solar radiation
sensor and capture the cable as it was before you clipped the original
cable tie(s).
d. Replace the battery pack in its original location.
e. Replace the battery pack retainer and tighten the Phillips head screws
that hold it into the electronics section. Take care not to crimp the
cable from the battery pack or the solar radiation sensor under the
battery pack, or the retainer.
f. Place the two sections of the weather station main body together,
making sure that none of the wiring bundles will be crushed by the
edges or by the seven housing screws when the two sections are
secured with screws.
50