Campbell TurfWeather, Инструкция по эксплуатации

Страница: 44 / 81

TurfWeather Weather Station
b. Remove the seven Phillips head screws on the base of the main body
that hold the base section to the electronics enclosure section. Do not
remove the Phillips head screws that connect the mast bracket to the
weather station base. Notice that the three screws along the end with
the wind sensors are shorter than the remaining four screws.
c. Gently separate the electronics enclosure and base sections of the
weather station main body, taking care not to place any stress on the
wires that connect the two sections.
d. Rest the base section next to the electronics section and locate the
battery pack within the electronics section. It is a gray and black
rectangular component at the front of the electronics section. It is
retained by a white metal bracket that is held in place with two
Phillips head screws. There is a cable, consisting of a red and a black
wire, or a white and black wire that connects the battery pack to the
main electronics board.
e. Locate the other end of the battery pack cable on the main electronics
board. It terminates in a white connector plugged into the main
electronics board marked “Battery”. The wires are restrained along
their length with either plastic cable ties, or with reusable cable
restraints. Determine which type your weather station has and then
release the wires by either cutting the cable ties with the small wire
cutter, or by releasing the cable restraints. NOTE: Do not cut the wires
to remove the battery pack.
37