Campbell TurfWeather, Инструкция по эксплуатации

Страница: 38 / 81

TurfWeather Weather Station
2.4.1.8 Procedure 7: 17342 Short-Haul Modem installation
1. Attach the enclosure from 17342 kit onto the tripod or mounting pipe
under the TurfWeather weather station using the U-Bolts supplied. Mount
this underneath or opposite of the solar panel if used to prevent shadowing
on the solar panel. See Figure 2-16.
2. Connect 17326 cable to the connector on the bottom of the enclosure
marked “Weather Station”. Connect the other end of this cable to the
bottom of the weather station marked “RS232” and thread the thumb
screws into the connector to secure cable connector to weather station.
See Figures 2-17 and 2-18.
3. Connect the 12002 cable to the connector on the bottom of the enclosure
marked “Computer”. The other end of this cable has four wires that are
labelled as follows: Red “+RCV”, Black “-RCV”, Green “+XMT”, White
“-XMT”. Connect these wires to the customer supplied cable using the
direct burial splice kits. The wire used from the user supplied cable to
connect to the Red “+RCV” wire should be connected to the terminal
marked “+RCV” on the short haul modem used on the computer end of
cable run. The remaining wires should follow the same procedure so that
each wire is connected to the corresponding terminal on the short haul
modem. Black to “-RCV”, etc.
4. On the computer end of the user supplied cable connect the wires as
described above to the SRM-5A short haul modem. The connector marked
“+RCV” should be connected to the wire in the user supplied cable that
connects to the Red wire on the 12002 cable and so on.
5. Connect the 15751 9 to 25 pin adapter to the SRM-5A short haul modem.
6. Connect the serial cable to the 15751 adapter
7. Connect the other end of the serial cable to the computer.
31